MCC MIIC-203 Betriebsanweisung PDF herunterladen (Seite 48)

/Stext[CR]

Slave Transmit Message

Write the specified data bytes to a requesting I

C Master Receiver device.

/(*)Ttext[CR]

Master Transmit Message

Master Transmit the specified data bytes to the current Destination I

C Slave

device. * = No Stop for Repeated Start.

/Un[CR]

C Bus Time-oUt

Set I2C Bus Time-oUt in msec (0=Disable)

/V[CR]

Display Firmware Version

(Major XX.XX Minor) (Requires Firmware V2.0 or later)

/X[CR]

eXtended Commands

(See Prompt or User’s Guide) (Requires Firmware V2.0 or later)

/Y[CR]

Display Tx bYte Count (Requires Firmware V2.0 or later)

Synchronous Interface Events

Synchronous Events are those iPort/AFM interface activities initiated by the Host

computer.

iPort/AFM Reset

Reset iPort/AFM to its default state.

The reset command consists of three (3) sequential Ctrl/R characters. Ctrl/R is the

character code Decimal 18 and Hexadecimal 0x12. When using a terminal emulator

program, you can generate a Ctrl/R by holding down the Ctrl key and pressing the R

key.

Note: It is recommended that the Host computer turn off all serial port flow control

before sending this command to override any flow control from the I

C adapter that

could block the transmission. Flow control should be enabled once the response is

received.

Command: Ctrl/R,Ctrl/R,Ctrl/R ‘iPort Reset

Response. * ‘iPort/AFM Ready

Default Setting: None

Status Display

Display iPort/AFM status.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 70 71

Keine Kommentare

MCC MIIC-203 Betriebsanweisung Seite 48